Sorting Platygastroidea Identified Material

Introduction

This section contains procedures for handling Platygastroidea material that has been identified and whose specimen data has been transcribed.

Procedures

Remove a drawer from cabinet one. Make sure it is a drawer that has been sort to genus, not just family.
Grab a drawer of unit trays for the material to be sorted into from cabinet seven.
- Make sure you have a good mixture of small and medium-sized soft unit trays and one hard-bottomed tray to place excess labels in.
Scan the drawer of specimens to be sorted and look for the first alphabetically. Working your way through the drawer, remove all specimens of that type and place them together in a single unit tray
- If there are too many to fit in one unit try, move onto a second, but do not forget to place a label at the upper left corner of that tray as well.
- If a row of specimens has a determination label at the beginning, do not mix those in even with specimens of the same genus. They can be placed in the same unit try but must remain separate.
Continue this process until all specimens are sorted alphabetically by genus.
- When you come across any of the genera listed on the Target List, or any genus followed by MS or preceded by "nr.", make sure to remove them and place them in the VIBs (Very Important Bugs) Drawer located toward the bottom of cabinet one.
After you have sorted two or three individual drawers into genus, you may choose to combine these drawers together (using similar protocol as above) as this will make the next step more efficient.

In cabinet eight, you will see a few dozen drawers with letters on the front. Scan your sorted genera and use the carts to grab the first four or five drawers you will need.
- It is actually time-saving to note which drawers will be necessary. For example, if you grabbed drawers A through F but you did not have any genera that began with 'B' to place in them, you have made unnecessary work for yourself.
- Some drawers in cabinet eight will be used specifically for one genus. This if often the case for genera of which the collection has many, i.e., Telenomus. When these become full, follow the instructions in the next subsection.
Place the genera into the correctly labeled drawers, trying to keep them in alphabetical order within the new drawers as well. When you have finished with the first load, take them back and continue the process until all genera have been sorted into cabinet eight.
- If you come across a specimen that does not belong to OSUC, as indicated by a colored tag on the pin, you will need to sort them in a similar fashion into the Collections drawers located in cabinets nine and ten.

raw